FTDI FT232RL USB Interface Chip
Model Name/Number | FT232RL |
Weight | 550 mg |
Manufacturer | FTDI |
Mounting Type | SMD/SMT |
Series | FT232 |
Type | Bridge, USB to UART |
Speed | Full Speed |
Data Rate | 12 Mb/s |
Operating Supply Current | 25 mA |
Minimum Operating Temperature | – 40 Deg C |
Maximum Operating Temperature | + 85 Deg C |
Interface Type | UART |
Moisture Sensitive | Yes |
Operating Supply Voltage | 1.8 V to 5.25 V |
Description
FTDI FT232RL USB Interface Chip
Options:-
- Single chip USB to asynchronous serial information switch interface.
- Complete USB protocol dealt with on the chip. No USB particular firmware programming required.
- Absolutely built-in 1024 bit EEPROM storing system descriptors and CBUS I/O configuration.
- Absolutely built-in USB termination resistors. Absolutely built-in clock era with no exterior crystal required plus non-obligatory clock output choice enabling a glue-less interface to exterior MCU or FPGA.
- Knowledge switch charges from 300 baud to three Mbaud (RS422, RS485, RS232) at TTL ranges. 128 byte obtain buffer and 256 byte transmit buffer utilising buffer smoothing know-how to permit for prime information throughput. FTDI’s royalty-free Digital Com Port (VCP) and Direct (D2XX) drivers eradicate the requirement for USB driver growth normally.
- Distinctive USB FTDIChip-ID™ characteristic.
- Configurable CBUS I/O pins.
- Transmit and obtain LED drive alerts.
- UART interface assist for 7 or 8 information bits, 1 or 2 cease bits and odd / even / mark / house / no parity
- FIFO receives and transmits buffers for prime information throughput.
- Synchronous and asynchronous bit bang interface choices with RD# and WR# strobes. System provided pre-programmed with distinctive USB serial quantity.
- Helps bus powered, self-powered and highpower bus powered USB configurations. Built-in +3.3V stage converter for USB I/O.
- Built-in stage converter on UART and CBUS for interfacing to between +1.8V and +5V logic.
- True 5V/3.3V/2.8V/1.8V CMOS drive output and TTL enter.
- Configurable I/O pin output drive power.
- Built-in power-on-reset circuit.
- Absolutely built-in AVCC provide filtering – no exterior filtering required.
- UART sign inversion possibility.
- +3.3V (utilizing exterior oscillator) to +5.25V (inner oscillator) Single Provide Operation. Low working and USB droop present.
- Low USB bandwidth consumption.
- UHCI/OHCI/EHCI host controller appropriate. USB 2.0 Full Pace appropriate.
- -40°C to 85°C prolonged working temperature vary.
- Obtainable in compact Pb-free 28 Pin SSOP and QFN-32 packages (each RoHS compliant).