USB Interface Chip – Dilson Enterprises https://dilsonenterprises.com Mon, 31 Mar 2025 03:32:36 +0000 en-US hourly 1 https://wordpress.org/?v=6.9.1 https://dilsonenterprises.com/wp-content/uploads/2022/03/cropped-favicon-32x32.png USB Interface Chip – Dilson Enterprises https://dilsonenterprises.com 32 32 Built-in Circuits https://dilsonenterprises.com/usb-interface-chip/built-in-circuits/ Mon, 19 Sep 2022 04:10:50 +0000 https://dilsonenterprises.com/?post_type=product&p=10294 Usage/Application Electronics

The post Built-in Circuits appeared first on Dilson Enterprises.

]]> Built-in Circuits

The post Built-in Circuits appeared first on Dilson Enterprises.

]]> FTDI FT232RL USB Interface Chip https://dilsonenterprises.com/usb-interface-chip/ftdi-ft232rl-usb-interface-chip/ Mon, 19 Sep 2022 04:07:09 +0000 https://dilsonenterprises.com/?post_type=product&p=10288

Product Brochure

Model Name/Number FT232RL
Weight 550 mg
Manufacturer FTDI
Mounting Type SMD/SMT
Series FT232
Type Bridge, USB to UART
Speed Full Speed
Data Rate 12 Mb/s
Operating Supply Current 25 mA
Minimum Operating Temperature - 40 Deg C
Maximum Operating Temperature + 85 Deg C
Interface Type UART
Moisture Sensitive Yes
Operating Supply Voltage 1.8 V to 5.25 V

The post FTDI FT232RL USB Interface Chip appeared first on Dilson Enterprises.

]]> FTDI FT232RL USB Interface Chip

Options:-

  • Single chip USB to asynchronous serial information switch interface.
  • Complete USB protocol dealt with on the chip. No USB particular firmware programming required.
  • Absolutely built-in 1024 bit EEPROM storing system descriptors and CBUS I/O configuration.
  • Absolutely built-in USB termination resistors. Absolutely built-in clock era with no exterior crystal required plus non-obligatory clock output choice enabling a glue-less interface to exterior MCU or FPGA.
  • Knowledge switch charges from 300 baud to three Mbaud (RS422, RS485, RS232) at TTL ranges. 128 byte obtain buffer and 256 byte transmit buffer utilising buffer smoothing know-how to permit for prime information throughput. FTDI’s royalty-free Digital Com Port (VCP) and Direct (D2XX) drivers eradicate the requirement for USB driver growth normally.
  • Distinctive USB FTDIChip-ID™ characteristic.
  • Configurable CBUS I/O pins.
  • Transmit and obtain LED drive alerts.
  • UART interface assist for 7 or 8 information bits, 1 or 2 cease bits and odd / even / mark / house / no parity
  • FIFO receives and transmits buffers for prime information throughput.
  • Synchronous and asynchronous bit bang interface choices with RD# and WR# strobes. System provided pre-programmed with distinctive USB serial quantity.
  • Helps bus powered, self-powered and highpower bus powered USB configurations. Built-in +3.3V stage converter for USB I/O.
  • Built-in stage converter on UART and CBUS for interfacing to between +1.8V and +5V logic.
  • True 5V/3.3V/2.8V/1.8V CMOS drive output and TTL enter.
  • Configurable I/O pin output drive power.
  • Built-in power-on-reset circuit.
  • Absolutely built-in AVCC provide filtering – no exterior filtering required.
  • UART sign inversion possibility.
  • +3.3V (utilizing exterior oscillator) to +5.25V (inner oscillator) Single Provide Operation. Low working and USB droop present.
  • Low USB bandwidth consumption.
  • UHCI/OHCI/EHCI host controller appropriate. USB 2.0 Full Pace appropriate.
  • -40°C to 85°C prolonged working temperature vary.
  • Obtainable in compact Pb-free 28 Pin SSOP and QFN-32 packages (each RoHS compliant).

The post FTDI FT232RL USB Interface Chip appeared first on Dilson Enterprises.

]]>