The MKR WIFI 1010 is a major enchancment on the MKR 1000 WIFI. It’s geared up with an ESP32 module made by U-BLOX. This board goals to hurry up and simplify the prototyping of WIFI primarily based IoT functions due to the pliability of ESP32 module and it’s low energy consumption.
The Arduino MKR WiFi 1010 is the best level of entry to fundamental IoT and pico-network software design. Whether or not you’re looking at constructing a sensor community related to your workplace or house router, or if you wish to create a BLE system sending information to a cellphone, the MKR WiFi 1010 is your one-stop-solution for lots of the fundamental IoT software eventualities.
This skinny board has been designed to supply a sensible and cost-effective resolution for makers to design IoT initiatives with minimal earlier expertise in networking. It’s primarily based on the low energy Arm® Cortex®-M0 32-bit SAMD21, which is a part of the Arduino MKR household. Wi-fi gadgets particularly designed for the Web of Issues (IoT).The board’s most important processor is a low energy Arm® Cortex®-M0 32-bit SAMD21, like within the different boards throughout the Arduino MKR household. The WiFi and Bluetooth® connectivity is carried out with a module from u-blox, the NINA-W10, a low energy chipset working within the 2.4GHz vary. On prime of these, safe communication is ensured by means of the Microchip® ECC508 crypto chip. Moreover that, yow will discover a battery charger, and a directionable RGB LED on-board.
Discription : Arduino MKR WIFI 1010 Board
- The MKR WIFI 1010 consists of 32- bit computational energy, the same old wealthy set of I/O interfaces, and low energy Wi-Fi with Cryptochip for safe communication utilizing SHA-256 encryption.
- It provides ease of use Arduino Software program (IDE) for the rising IoT battery-powered initiatives in a compact kind.
- It’s USB port can be utilized to provide energy (5V) to the board. It has a Li-Po charging circuit that permits the Arduino MKR WiFi 1010 to run on battery energy or an exterior 5 volt supply, charging the Li-Po battery whereas working on exterior energy.
Product Particulars:
| Minimal Order Amount | 1 Piece |
| Mannequin Title/Quantity | mkr1010 |
| Digital I/O Pin | 8 Pins |
| Microcontroller | SAMD21 Cortex- M0+32 bit low energy ARM MCU |
| Radio Module | U- Blox NINA-W 102 |
| Board energy provide (USB/VIN) | 5V |
| Safe ingredient | ATECCC508 |
| Supported battery | Li-Po single cell,3.7V,1024 mAh minimal |
| Circuit working voltage | 3.3 V |
| Analog enter pins | 7 (ADC 8/10/12 bit) |
| Analog output pins | 1 (DAC 10 bit) |
| Exterior interrupts | 8 (0,1,4,5,6,7,8,16/A1,17/A2) |
| DC present per I/O pin | 7 mA |
| CPU flash reminiscence | 256 KB (inner) |
| SRAM | 32 Kb |
| Clock velocity | 32.768 kHz (RTC),48 MHz |
| Weight | 32 gm |
| Measurement | 61.5mm x 25mm |
