E-Paper 2.13″ HAT for Raspberry Pi Show Module
This is an E-Ink display HAT for Raspberry Pi, 2.13inch, 250×122 resolution, with embedded controller, communicating via SPI interface, supports partial refresh.
Features: E – Ink Display HAT for Raspberry Pi
- No backlight, keeps displaying last content for a long time even when power down
- Ultra low power consumption, basically power is only required for refreshing
- Compatible with Raspberry Pi 2B/3B/Zero/Zero W
- Preserved solder pads for SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc.
- Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
17
People watching this product now!
Description
That is an E-Ink show HAT for Raspberry Pi, 2.13inch, 250×122 decision, with embedded controller, speaking through SPI interface, helps partial refresh.
Because of the benefits like extremely low energy consumption, extensive viewing angle, nice impact below daylight, it is a perfect alternative for purposes akin to shelf label, industrial instrument, and so forth.
Options:
- No backlight, retains displaying final content material for a very long time even when energy down
- Extremely low energy consumption, principally energy is just required for refreshing
- Suitable with Raspberry Pi 2B/3B/Zero/Zero W
- Preserved solder pads for SPI interface, for connecting with different controller boards like Arduino/Nucleo, and so forth.
- Comes with improvement sources and handbook (examples for Raspberry Pi/Arduino/STM32)
Interface
| SYMBOL | DESCRIPTION |
|---|---|
| VCC | 3.3V |
| GND | Floor |
| NC | NC |
| DIN | SPI MOSI pin |
| CLK | SPI SCK pin |
| CS | SPI chip choice, low lively |
| DC | Information/Command choice (excessive for information, low for command) |
| RST | Exterior reset, low lively |
| BUSY | Busy standing output, low lively |
