OLED 4pin 128×64 Show Module 0.96″ Yellow Blue Coloration
This is a 0.96 inch white OLED display (Yellow- Blue) module. The display module can be interfaced with any microcontroller using SPI/IIC protocols. It is having a resolution of 128×64. The package includes display board,display, 4 pin male header presoldered to board.
Specifications: 0.96 inch white OLED display (Yellow- Blue) module
- Viewing angle : greater than 160 degrees
- Supported platforms : for arduino, 51 series, MSP430 series, STIM32 / 2, SCR chips
- Low power consumption : 0.04W during normal operation
- Support wide voltage : 3.3V-5V DC
- Driver IC : SSD1306
- Communication : IIC, only two I / O ports
- No font : The software takes word modulo
- Back light : OLED self light, no backlight
- Interface: VCC: 3.3-5V GND: Ground SCL: Serial Clock SDA: Serial Dat
Description
It is a 0.96 inch white OLED show (Yellow- Blue) module. The show module might be interfaced with any microcontroller utilizing SPI/IIC protocols. It’s having a decision of 128×64. The bundle consists of show board,show, 4 pin male header presoldered to board.
OLED (Natural Gentle-Emitting Diode) is a self light-emitting expertise composed of a skinny, multi-layered natural movie positioned between an anode and cathode. In distinction to LCD expertise, OLED does not require a backlight. OLED possesses excessive utility potential for nearly every kind of shows and is taken into account the final phrase expertise for subsequent era of flat-panel shows. Dimensions: 27.5 × 27.8 × 11.3mm Show Measurement: 21.74 × 10.86 Drive voltage: 2.8-3.3V (with computerized increase) Driver IC: SSD1306 Help Interface: 8 parallel port, 3/4-wire SPI, I2C Coloration: yellow and blue shade Traits: large viewing angle, excessive distinction, low energy consumption, seen underneath the solar.
OLEDs fundamental construction consists of natural supplies positioned between the cathode and subsequently the anode, which consists {of electrical} conductive clear Indium Tin Oxide (ITO). The natural supplies compose a multi-layered skinny movie, which contains the opening Transporting Layer (HTL), Emission Layer (EML) and subsequently the Electron Transporting Layer (ETL). By making use of the suitable electrical voltage, holes and electrons are injected into the EML from the anode and subsequently the cathode, respectively. The holes and electrons mix contained in the EML to make excitons, after which electro luminescence happens. The switch materials, emission layer materials and number of electrode are the important thing components that decide the usual of OLED parts.
The traits of this show module are excessive brightness, self-emission, excessive distinction ratio, slim/skinny define, large viewing angle, large temperature vary and low energy consumption.
OLED show, no want backlight, self-illumination, the show efficiency is greatest than the conventional LCD show, additionally decrease consumption. I2C interface, requires solely two sign pin. It Comes with improvement assets and handbook (examples for Raspberry Pi/Jetson Nano/Arduino/STM32).
